Question Family: Remotes and Access Control

Direct answer: Yes. When a vehicle-detection loop is connected to the exit-loop input, the control board can open the gate when a vehicle drives into the loop area.

That is commonly used for free exit from inside a property.

Direct answer: Yes. Eagle’s manuals show external loop detectors as an option. Follow the external detector’s wiring instructions and connect its output to the correct Diamond-board input.

The plug-in EG169 is a different setup and has its own board-revision limits.

Direct answer: A shadow loop, also called a phantom loop, watches the area where the gate moves when it is fully open. Its job is to keep the gate from starting to close while a vehicle is still in that area.

On Eagle Diamond boards, the shadow-loop input is not active the same way at every point in gate travel, so the input should be used exactly as the manual shows.

Direct answer: All three are Chrome-series keychain remotes for EG650 and EG652 receivers. The main difference is the number of buttons: EG640 has 1, EG643 has 2, and EG644 has 4.

Why more buttons matter

Extra buttons can be useful when you want one remote to handle more than one gate or access point, as long as each one has a compatible receiver.

#ad See the 2-button EG643

#ad See the 4-button EG644

Direct answer: EG642 is a one-button visor remote. EG646 is a four-button visor remote. Both work with EG650 and EG652 Chrome receivers.

If you only have one gate, one button may be all you need. If you have several compatible gates or access points, the four-button model gives you more room.

#ad See the 4-button EG646

Direct answer: If your Eagle 200 has an EG650 or EG652 Chrome receiver, use an Eagle Chrome remote such as EG640 or EG642. If the receiver was changed, match the remote to the receiver that is actually installed.

#ad See the EG642 visor remote

See the full Eagle 200 model record.

Direct answer: The same rule applies to the Eagle 200 DM: the receiver decides the remote. EG650 or EG652 Chrome receivers work with Chrome-series remotes.

See why the receiver matters.

Direct answer: An Eagle 2000 FR 1 HP using an EG650 or EG652 receiver can use Eagle Chrome remotes. A different receiver may need a different remote.

#ad See the EG642 visor remote

Direct answer: Check the receiver first. If the APT is using an EG650 or EG652 Chrome receiver, Chrome remotes such as EG640 and EG642 are a match.

The APT itself does not lock you into one remote family because the receiver can be changed.

Direct answer: The opener model alone does not determine the remote. If your Eagle 1000 FR is using an Eagle Chrome EG650 or EG652 receiver, Eagle documents Chrome-series transmitters such as EG640 and EG642 as compatible.

#ad See the EG642 visor remote

What to check first

Open the control box and identify the receiver. Eagle’s own manuals say the operator can accept 3-wire or 4-wire receivers, including other brands. If someone replaced the original receiver, the correct remote follows that receiver, not the Eagle 1000 name on the operator.

For the receiver side of the system, see the EG650 receiver page.